A low-power interface for the readout and motion-control of a MEMS capacitive sensor

A low-power interface for readout and motion-control of a MEMS capacitive sensor is presented. The interface consists of a hybrid third-order sigma-delta modulator. The interface enhances the linearity and stability of the sensor by applying force feedback through bias voltage modulation. The modulator employs a hybrid, continuous + discrete-time topology, to reduce power consumption by avoiding a separate pre-amplifier for the sensor. Power consumption in the modulator is further reduced by an op-amp sharing scheme. The interface is designed in 0.35 um CMOS technology and is simulated in Cadence-Spectre. Simulation results are shown for a MEMS capacitive microphone.

[1]  Alvise Bagolini,et al.  FABRICATION OF A PISTON-TYPE CONDENSER MICROPHONE WITH STRUCTURED POLYSILICON DIAPHRAGM , 2004 .

[2]  R. R. Harrison,et al.  A low-power low-noise CMOS amplifier for neural recording applications , 2003, IEEE J. Solid State Circuits.

[3]  Roger T. Howe,et al.  Surface micromachined, digitally force-balanced accelerometer with integrated CMOS detection circuitry , 1992, Technical Digest IEEE Solid-State Sensor and Actuator Workshop.

[4]  William Redman-White,et al.  Force feedback linearization for higher-order electromechanical sigma-delta modulators , 2006 .

[5]  Morrow Paul,et al.  A 0.18um 102dB-SNR Mixed CT SC Audio-Band delta-sigma ADC , 2005 .

[6]  R. Oboe,et al.  Modelling and control of IRST MEMS microphone , 2006, 9th IEEE International Workshop on Advanced Motion Control, 2006..

[7]  Reid R. Harrison,et al.  A low-power, low-noise CMOS amplifier for neural recording applications , 2002, 2002 IEEE International Symposium on Circuits and Systems. Proceedings (Cat. No.02CH37353).

[8]  A. Baschirotto,et al.  A low-voltage boostrapping technique for capacitive MEMS sensors interface , 2007, 2007 IEEE Instrumentation & Measurement Technology Conference IMTC 2007.

[9]  Bernhard E. Boser,et al.  A three-axis micromachined accelerometer with a CMOS position-sense interface and digital offset-trim electronics , 1999, IEEE J. Solid State Circuits.

[10]  Gilles Amendola,et al.  Signal processing electronics for a capacitive microsensor , 2000, Design, Test, Integration, and Packaging of MEMS/MOEMS.

[11]  Gilles Amendola,et al.  Signal-Processing Electronics for a Capacitive Micro-Sensor , 2001 .