Efficiency analysis of utilizing phase change materials as grout for a vertical U-tube heat exchanger coupled ground source heat pump system

Abstract To study the effects of using phase change materials (PCMs) as grout on the efficiency of a ground source heat pump (GSHP) system, a numerical GSHP system model was established in this study, considering both the site conditions and dynamically changing loads regulated by the heat pump. First, system efficiencies of using an ordinary grout and two other PCM grouts were investigated and compared. Second, the applicability of PCM grouts to different soil environments was investigated by analyzing the effects of subsurface characteristics on the heat exchanger efficiency. Finally, the appropriate operation mode for PCM-backfilled GSHP system was determined by comparing the effects of daily running modes with various intermittent ratios on the system performance. The results show that it is necessary to consider the effect of heat pump, especially for poor heat transfer conditions. PCM grouts with a low thermal conductivity will significantly reduce the system efficiency, whereas PCM grouts with a thermal conductivity comparable to that of an ordinary grout will improve the efficiency and operational stability of a GSHP system. A higher soil thermal conductivity and Darcy velocity improve the heat exchanger efficiency, and PCM grouts with a high thermal conductivity are more suitable for areas where the groundwater is not rich. Sufficient recovery time is necessary and important for a PCM-backfilled GSHP system to ensure operational stability and sustainability and the effectiveness of thermal radius reduction.

[1]  Yanzhong Li,et al.  Numerical investigation on thermal performance of ground heat exchangers using phase change materials as grout for ground source heat pump system , 2016 .

[2]  Hangseok Choi,et al.  Characteristics of thermally-enhanced bentonite grouts for geothermal heat exchanger in South Korea , 2010 .

[3]  Yuehong Su,et al.  Heat transfer analysis of underground thermal energy storage in shallow trenches filled with encapsulated phase change materials , 2015 .

[4]  Daniel Castro-Fresno,et al.  Borehole thermal response and thermal resistance of four different grouting materials measured with a TRT , 2013 .

[5]  O. Kolditz,et al.  A numerical study on the sustainability and efficiency of borehole heat exchanger coupled ground source heat pump systems , 2016 .

[6]  V. Voller,et al.  A fixed grid numerical modelling methodology for convection-diffusion mushy region phase-change problems , 1987 .

[7]  Yuehong Su,et al.  Numerical analysis of a novel ground heat exchanger coupled with phase change materials , 2015 .

[8]  Jinfeng Mao,et al.  Quantitative evaluation of improper backfilling in vertical borehole , 2016 .

[9]  Hongxing Yang,et al.  Vertical-borehole ground-coupled heat pumps: A review of models and systems , 2010 .

[10]  Zhaohong Fang,et al.  Investigation on influential factors of engineering design of geothermal heat exchangers , 2015 .

[11]  Ahmad Fakheri,et al.  Efficiency analysis of heat exchangers and heat exchanger networks , 2014 .

[12]  Lin Duanmu,et al.  Research on U-tube Heat Exchanger with Shape-stabilized Phase Change Backfill Material , 2016 .

[13]  Lin Duanmu,et al.  Study of a U-tube heat exchanger using a shape-stabilized phase change backfill material , 2017 .

[14]  J. Lund,et al.  Direct utilization of geothermal energy 2015 worldwide review , 2011 .

[15]  Ni Liu,et al.  Numerical Simulation of Borehole Heat Transfer with Phase Change Material as Grout , 2014 .

[16]  Gerd Vandersteen,et al.  Heat transfer in a borehole heat exchanger: Frequency domain modeling , 2014 .

[17]  Bertrand François,et al.  Efficiency of various grouting materials for borehole heat exchangers , 2014 .

[18]  Yuehong Su,et al.  Ground-Source Heat Pumps using Phase Change Materials , 2013 .

[19]  Songtao Hu,et al.  Optimal design of borehole heat exchangers based on hourly load simulation , 2016 .

[20]  Yanping Yuan,et al.  Restoration performance of vertical ground heat exchanger with various intermittent ratios , 2015 .

[21]  Steve P. Kavanaugh,et al.  Thermal Conductivity of Cementitious Grouts and Impact On Heat Exchanger Length Design for Ground Source Heat Pumps , 1999 .

[22]  Olaf Kolditz,et al.  Efficiency and economic analysis of utilizing latent heat from groundwater freezing in the context of borehole heat exchanger coupled ground source heat pump systems , 2016 .

[23]  E. Korin,et al.  Incorporation of Phase-Change Materials Into a Ground Thermal Energy Storage System: Theoretical Study , 1996 .

[24]  Hideo Mori,et al.  An experimental study on characteristics of post-CHF heat transfer in the high subcritical pressure region near to the critical pressure , 2016 .

[25]  Daehoon Kim,et al.  Experimental and numerical investigation of thermal properties of cement-based grouts used for vertical ground heat exchanger , 2017 .

[26]  Andrew Dawson,et al.  Enhancement of Soil Thermo-Physical Properties Using Microencapsulated Phase Change Materials for Ground Source Heat Pump Applications , 2011 .

[27]  J. C. Jaeger,et al.  Conduction of Heat in Solids , 1952 .

[28]  Hangseok Choi,et al.  Viscosity and salinity effect on thermal performance of bentonite-based grouts for ground heat exchanger , 2014 .

[29]  Benamar Bouhacina,et al.  Numerical investigation of a novel tube design for the geothermal borehole heat exchanger , 2015 .

[30]  Hua Zhang,et al.  Numerical simulation of horizontal spiral-coil ground source heat pump system: Sensitivity analysis and operation characteristics. , 2017 .

[31]  R. Ooka,et al.  Effect of natural convection on thermal response test conducted in saturated porous formation: Comparison of gravel-backfilled and cement-grouted borehole heat exchangers , 2016 .

[32]  Gao Jun,et al.  Evaluation of heat exchange rate of GHE in geothermal heat pump systems. , 2009 .