Can DC Motors Directly Drive Flapping Wings at High Frequency and Large Wing Strokes?

This paper proposes and experimentally validates a method for driving flapping wings at large wing strokes and high frequencies with a DC motor, based on direct, elastic transmission. The DC motor undergoes reciprocating, rather than rotary, motion avoiding the use of nonlinear transmissions such as slider-crank mechanisms. This is key to compact, easy to fabricate, power efficient, and controllable flapping mechanisms. First, an appropriate motor based on maximum power transfer arguments is selected. Then, a flapping mechanism is prototyped and its experimental performance is compared with simulations, which take into account the full dynamics of the system. Despite inherent nonlinearities due to the aerodynamic damping, the linearity of the direct, elastic transmission allows one to fully exploit resonance. This benefit is best captured by the dynamic efficiency, close to 90% at larger wing strokes in both experimental data and simulations. We finally show a compact flapping mechanism implementation with independent flapping motion control for the two wings, which could be used for future autonomous micro-aerial vehicles.

[1]  Hod Lipson,et al.  A Passively Stable Hovering Flapping Micro-Air Vehicle , 2010, Flying Insects and Robots.

[2]  S. Sane,et al.  Aerodynamic effects of flexibility in flapping wings , 2010, Journal of The Royal Society Interface.

[3]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[4]  C. Ellington.  The Aerodynamics of Hovering Insect Flight. VI. Lift and Power Requirements , 1984 .

[5]  D. Lachat,et al.  BoxyBot: a swimming and crawling fish robot controlled by a central pattern generator , 2006, The First IEEE/RAS-EMBS International Conference on Biomedical Robotics and Biomechatronics, 2006. BioRob 2006..

[6]  Sunil Kumar Agrawal,et al.  Design of flapping mechanisms based on transverse bending phenomena in insects , 2006, Proceedings 2006 IEEE International Conference on Robotics and Automation, 2006. ICRA 2006..

[7]  Domenico Campolo,et al.  Motor selection via impedance-matching for driving nonlinearly damped, resonant loads , 2010 .

[8]  Sunil K. Agrawal,et al.  Biologically Inspired Design Of Small Flapping Wing Air Vehicles Using Four-Bar Mechanisms And Quasi-steady Aerodynamics , 2005 .

[9]  Isao Shimoyama,et al.  Microrobot actuated by a vibration energy field , 1994 .

[10]  Ronald S. Fearing,et al.  Efficient resonant drive of flapping-wing robots , 2009, 2009 IEEE/RSJ International Conference on Intelligent Robots and Systems.

[11]  M. Goldfarb,et al.  The Development of Elastodynamic Components for Piezoelectrically Actuated Flapping Micro-Air Vehicles , 2002 .

[12]  C. Ellington,et al.  Clapping-wing Micro Air Vehicle of Insect Size , 2008 .

[13]  T. Weis-Fogh.  Quick estimates of flight fitness in hovering animals , 1973 .

[14]  Paul Keim,et al.  Do muscles function as adaptable locomotor springs? , 2002, The Journal of experimental biology.

[15]  Gregory H. Miller,et al.  Neurotechnology for biomimetic robots , 2002 .

[16]  S. Shankar Sastry,et al.  Controllability issues in flapping flight for biomimetic micro aerial vehicles (MAVs) , 2003, 42nd IEEE International Conference on Decision and Control (IEEE Cat. No.03CH37475).

[17]  T. Weis-Fogh.  Energetics of Hovering Flight in Hummingbirds and in Drosophila , 1972 .

[18]  Ronald S. Fearing,et al.  Development of PZT and PZN-PT based unimorph actuators for micromechanical flapping mechanisms , 2001, Proceedings 2001 ICRA. IEEE International Conference on Robotics and Automation (Cat. No.01CH37164).