Propeller shrouding influence on lift force of mini unmanned quadcopter

This article discusses the lift force generated by a mini unmanned aerial vehicle. Shrouded propellers were considered and analyses of shroud influence on lift force and energy saving were done. By help of laboratory experiments and computational fluid dynamics simulations (propeller velocity varied from 1000 rpm to 6000 rpm, shroud height from 20 mm to 60 mm, gap from 3 mm to 28 mm), it was shown that the shroud diameter influenced the rotor energy consumption up to 30% at velocities of more than 4000 rpm. With the increase shroud diameter (increase of distance between shroud and propeller borders), the lifting force increased. A gap of more than 30 mm practically did not influence the lifting force. Shroud height (from 20 mm to 60 mm, gap is 28 mm) also influenced the propeller efficiency (up to 10%) on small shroud heights (up to 30 mm). With the increase of the shroud height, the lift force decreased about 3% and then it increased up to 12%. From a value of about 50 millimetres, this influence will be unchanged but the total lifting force will be about 5% less in comparison with the force produced by propeller without shroud.

[1]  Zdzisław Gosiewski,et al.  Modelling of Dynamic and Control of Six-Rotor Autonomous Unmanned Aerial Vehicle , 2013 .

[2]  P. Sofer,et al.  Multicopter potentialities , 2012, Proceedings of the 13th International Carpathian Control Conference (ICCC).

[3]  Mark R. McCord,et al.  Roadway traffic monitoring from an unmanned aerial vehicle , 2006 .

[4]  Keiji Nagatani,et al.  Evaluation of Hovering Thrust Performance of Shrouded Rotors for Multi-rotor UAVs to Reduce Weight , 2015 .

[5]  Gwangtim Timothy Poyi,et al.  Modelling and simulation of a quad-rotor helicopter , 2012 .

[6]  A. Hatziefremidis,et al.  Energy Efficiency Optimization in UAVs: A Review , 2014 .

[7]  Lin Feng,et al.  Integration and Implementation of a Low-cost and Vision-based UAV Tracking System , 2006, 2007 Chinese Control Conference.

[8]  Farid Kendoul,et al.  Survey of advances in guidance, navigation, and control of unmanned rotorcraft systems , 2012, J. Field Robotics.

[9]  Jan Gebauer,et al.  Measurements of features of the ducted fan as a possible actuator of a multi-copter vehicle , 2011, 2011 12th International Carpathian Control Conference (ICCC).

[10]  Wei Zhang,et al.  Modeling and aerodynamic analysis of a ducted-fan micro aerial vehicle , 2012, 2012 Proceedings of International Conference on Modelling, Identification and Control.

[11]  Antonio Barrientos,et al.  Lift Failure Detection and Management System for Quadrotors , 2013, ROBOT.

[12]  Jongsoo Lee,et al.  Approximate multi-objective optimization of a quadcopter through proportional-integral-derivative control , 2015 .

[13]  Amelia Wong Azman,et al.  Indoor UAV Positioning Using Stereo Vision Sensor , 2012 .

[14]  J.K. Hedrick,et al.  A mode-switching path planner for UAV-assisted search and rescue , 2005, Proceedings of the 44th IEEE Conference on Decision and Control.

[15]  Mostafa Hassanalian,et al.  A new method for design of fixed wing micro air vehicle , 2015 .

[16]  M. Funaki,et al.  Outline of a small unmanned aerial vehicle (Ant-Plane) designed for Antarctic research , 2008 .

[17]  Antonio Barrientos,et al.  Mini-UAV Based Sensory System for Measuring Environmental Variables in Greenhouses , 2015, Sensors.

[18]  Kimon P. Valavanis,et al.  Advances in Unmanned Aerial Vehicles: State of the Art and the Road to Autonomy , 2007 .

[19]  Charles F. Wisniewski,et al.  Designing Small Propellers for Optimum Efficiency and Low Noise Footprint , 2015 .

[20]  Keiji Nagatani,et al.  Flow visualization of separation on a shrouded rotor inlet in a crosswind , 2015 .

[21]  Li Li,et al.  Unmanned Aerial Vehicle Route Planning for Traffic Information Collection , 2012 .

[22]  Claire J. Tomlin,et al.  Quadrotor Helicopter Flight Dynamics and Control: Theory and Experiment , 2007 .

[23]  Gaurav S. Sukhatme,et al.  Visual servoing of an autonomous helicopter in urban areas using feature tracking , 2006, J. Field Robotics.

[24]  Keiji Nagatani,et al.  Thrust loss saving design of overlapping rotor arrangement on small multirotor unmanned aerial vehicles , 2016, 2016 IEEE International Conference on Robotics and Automation (ICRA).

[25]  Philippe Martinet,et al.  Vision-based navigation of unmanned aerial vehicles , 2010 .

[26]  Antonio Barrientos,et al.  A proposal of methodology for multi-UAV mission modeling , 2015, 2015 23rd Mediterranean Conference on Control and Automation (MED).

[27]  Kenneth W. Van Treuren,et al.  The Influence of Airfold Shape, Tip Geometry, Reynolds Number and Chord Strength on Small Propeller Performance and Noise , 2015 .

[28]  Kenneth W. Van Treuren,et al.  A Comparison of the Aerodynamic Performance and Aeroacoustic Behavior of Commercial and Custom Designed Quadcopter Propellers , 2017 .

[29]  Mostafa Hassanalian,et al.  Design, manufacturing, and flight testing of a fixed wing micro air vehicle with Zimmerman planform , 2017 .

[30]  Timothy W. McLain,et al.  Cooperative forest fire surveillance using a team of small unmanned air vehicles , 2006, Int. J. Syst. Sci..

[31]  Shigenori Sano,et al.  Least square based sliding mode control for a quad-rotor helicopter and energy saving by chattering reduction , 2016 .

[32]  Bruce Wiggins,et al.  Validation of a quad-rotor helicopter Matlab/Simulink and solidworks models , 2013 .

[33]  Eric N. Johnson,et al.  Adaptive Trajectory Control for Autonomous Helicopters , 2005 .

[34]  Eric N. Johnson,et al.  Multi-sensor navigation system for an autonomous helicopter , 2002, Proceedings. The 21st Digital Avionics Systems Conference.