New Integrated Control Technique for Two-Stage Server Power to Improve Efficiency Under the Light-Load Condition
暂无分享,去创建一个
[1] Alberto Rodriguez,et al. On the Maximum Bandwidth Attainable by Power Factor Correctors with a Standard Compensator , 2009, 2009 Twenty-Fourth Annual IEEE Applied Power Electronics Conference and Exposition.
[2] David M. Otten,et al. High efficiency power factor correction using interleaving techniques , 1992, [Proceedings] APEC '92 Seventh Annual Applied Power Electronics Conference and Exposition.
[3] Yen-Shin Lai,et al. Design of a Two-Stage AC/DC Converter with Standby Power Losses Less than 1 W , 2007, 2007 Power Conversion Conference - Nagoya.
[4] Ki-Bum Park,et al. On/Off Control of Boost PFC Converters to Improve Light-Load Efficiency in Paralleled Power Supply Units for Servers , 2014, IEEE Transactions on Industrial Electronics.
[5] J. A. Sabate,et al. A comparative study of a class of full bridge zero-voltage-switched PWM converters , 1995, Proceedings of 1995 IEEE Applied Power Electronics Conference and Exposition - APEC'95.
[6] Yen-Shin Lai,et al. Novel circuit design for two-stage AC/DC converter to meet standby power regulations , 2009 .
[7] Gerry Moschopoulos,et al. An Investigation on the Novel Use of High-Power Three-Level Converter Topologies to Improve Light-Load Efficiency in Low Power DC/DC Full-Bridge Converters , 2014, IEEE Transactions on Industrial Electronics.
[8] Jih-Sheng Lai,et al. Zero-Voltage-Switching PWM Resonant Full-Bridge Converter With Minimized Circulating Losses and Minimal Voltage Stresses of Bridge Rectifiers for Electric Vehicle Battery Chargers , 2013, IEEE Transactions on Power Electronics.
[9] Milan M. Jovanovic,et al. Light-Load Efficiency Optimization Method , 2009, 2009 Twenty-Fourth Annual IEEE Applied Power Electronics Conference and Exposition.
[10] Bong-Hwan Kwon,et al. Zero-Voltage- and Zero-Current-Switching Full-Bridge Converter With Secondary Resonance , 2010, IEEE Transactions on Industrial Electronics.
[11] Y. Jang,et al. A New PWM ZVS Full-Bridge Converter , 2007, IEEE Transactions on Power Electronics.
[12] Hang-Seok Choi,et al. Techniques to minimize Power Consumption of SMPS in Standby Mode , 2005, 2005 IEEE 36th Power Electronics Specialists Conference.
[13] Yen-Shin Lai,et al. Switching Control Technique of Phase-Shift-Controlled Full-Bridge Converter to Improve Efficiency Under Light-Load and Standby Conditions Without Additional Auxiliary Components , 2010, IEEE Transactions on Power Electronics.
[14] Jih-Sheng Lai,et al. Hybrid Resonant and PWM Converter With High Efficiency and Full Soft-Switching Range , 2012, IEEE Transactions on Power Electronics.
[15] Yen-Shin Lai,et al. A Family of Predictive Digital-Controlled PFC Under Boundary Current Mode Control , 2012, IEEE Transactions on Industrial Informatics.
[16] Jong-Woo Kim,et al. A Simple Switching Control Technique for Improving Light Load Efficiency in a Phase-Shifted Full-Bridge Converter with a Server Power System , 2014, IEEE Transactions on Power Electronics.
[17] Yen-Shin Lai,et al. Analysis and Design of Adapter Met Energy Efficiency Code under Standby Condition without Using Current Sensor and Hysteresis Circuit for Notebook Computer Applications , 2006 .
[18] Novel On-Line Maximum Duty Point Tracking Technique to Improve Two-Stage Server Power Efficiency and Investigation Into Its Impact on Hold-Up Time , 2014, IEEE Transactions on Industrial Electronics.
[19] Yen-Shin Lai,et al. New hybrid control technique to improve light load efficiency while meeting the hold-up time requirement for two-stage server power , 2013, 2013 IEEE Energy Conversion Congress and Exposition.
[20] Gun-Woo Moon,et al. Variable Delay Time Method in the Phase-Shifted Full-Bridge Converter for Reduced Power Consumption Under Light Load Conditions , 2013, IEEE Transactions on Power Electronics.
[21] V. Anunciada,et al. A new single phase power factor corrector converter , 2000, APEC 2000. Fifteenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.00CH37058).
[22] Yen-Shin Lai,et al. Bandwidth-based analysis and controller design of power factor corrector for universal applications , 2012, 2012 IEEE International Conference on Industrial Technology.
[23] Yu-Kang Lo,et al. A High-Efficiency AC-to-DC Adaptor With a Low Standby Power Consumption , 2008, IEEE Transactions on Industrial Electronics.
[24] Chuang Liu,et al. High-Efficiency Hybrid Full-Bridge–Half-Bridge Converter With Shared ZVS Lagging Leg and Dual Outputs in Series , 2013, IEEE Transactions on Power Electronics.
[25] Chas.P. Steinmetz,et al. On the law of hysteresis , 1984, Proceedings of the IEEE.
[26] Yen-Shin Lai,et al. Novel Digital-Controlled Transition Current-Mode Control and Duty Compensation Techniques for Interleaved Power Factor Corrector , 2010, IEEE Transactions on Power Electronics.
[27] M. Jovanovic,et al. A new family of full-bridge ZVS converters , 2004, IEEE Transactions on Power Electronics.
[28] Milan M. Jovanovic,et al. State-of-the-art, single-phase, active power-factor-correction techniques for high-power applications - an overview , 2005, IEEE Transactions on Industrial Electronics.
[29] P. Spanik,et al. Zero-Voltage and Zero-Current Switching Full-Bridge DC–DC Converter With Auxiliary Transformer , 2006, IEEE Transactions on Power Electronics.
[30] Z. Ye. Dual Half-Bridge DC–DC Converter With Wide-Range ZVS and Zero Circulating Current , 2013, IEEE Transactions on Power Electronics.
[31] Yungtaek Jang,et al. A Bridgeless PFC Boost Rectifier With Optimized Magnetic Utilization , 2009, IEEE Transactions on Power Electronics.
[32] Sang-Kyoo Han,et al. A Pulse-Frequency-Modulated Full-Bridge DC/DC Converter With Series Boost Capacitor , 2010, IEEE Transactions on Industrial Electronics.
[33] F.C. Lee,et al. Common Mode EMI Noise Suppression for Bridgeless PFC Converters , 2008, IEEE Transactions on Power Electronics.